Can-Bus and Pickups

Can-bus pulse

By Bridgewater Electronics.
Can-Bus Interface CANM8-PULSE, always the latest software

This is a plug & play unit, no need to be programmed.
Just wire it to a 12Volt supply, the two can-bus wires and pulse output to taximeter.
On purchase, we will email the latest list of where to fine the twisted pair of can-bus wires and Installation

Divider amp
This small electronic device takes the cars speed-pulse wire signal, amplify & cleans the signal, and then divides the signal by up to 30 times,
For uses with, Taximeters, Car Radio.
Operating Voltage…9 to 24 Vdc.
Input Sensitivity…0.15 to 24 volts.
Divide by 2, 4, 8, or 16. (30 )(4 link)
Size 41x27x16mm.

Divider Amp

Divider amp controls

The LED, will indicate that pulses are
present, very handy when looking for
the pulses wire.
Wiring Connections
RED………… + volts.
GREEN……. 0 volts.
BLUE………. pulses output to meter.
YELLOW….. input from cars wiring.

Inline Speedo Cable Sender

Inline Speedo Cable Sender

Fitting Instructions for Cable Sender

Pickup Sensor

Pickup Sensor