Canbus and Pickups
Can-Bus Interface CANM8-PULSE
By Bridgewater Electronics
This is a plug & play unit, no need to be programmed
Just wire it to a 12V supply, the two can-bus wires and pulse output to the taximeter.
On purchase, we will email the latest list of where to find the twisted pair can-bus wires and installation instructions.
This small electronic device takes the cars speed-pulse wire signal, amplifies and cleans the signal, and then divides the signal by up to 30 times.
For uses with taximeters, car radio.
- Operating Voltage 9 to 24 Vdc
- Input Sensitivity 0.15 to 24 Volts
- Divide by 2, 4, 8, or 16. (30) (4 link)
- Size 41x27x16mm
Divider amp controls
The LED will indicate that pulses are present, very handy when looking for the pulses wire.
- RED + Volts
- GREEN 0 Volts
- BLUE pulses output to meter
- YELLOW input from cars wiring
Inline Speedo Cable Sender
Inline speedo Cable Sender
Fitting Instructions for Cable Sender